ZHENGZHOU SHENGHONG HEAVY INDUSTRY TECHNOLOGY CO., LTD. sales@gcfertilizergranulator.com 86--15286833220
Every fertilizer producer eventually faces the same question: drum, disc or roller press? The three machines are not interchangeable grades of the same product. They build granules by three different mechanisms, and the mechanism decides which raw materials you can run, how much you spend on drying, and how strong the finished pellet is after a season in a warehouse.
Material tumbles inside a rotating cylinder while water, steam or a binder spray is added. Particles collide, stick and layer up into spheres. Drum lines tolerate high moisture, handle large tonnage, and produce round granules with good appearance — at the cost of a full drying and cooling section, because the product leaves the drum wet.
A tilted rotating pan rolls fines into spheres by centrifugal and frictional force. Disc machines are the lowest-capex route to round granules and are excellent for small organic lines and for recycling screened oversize. Output per unit is limited, the pan needs careful angle and spray adjustment, and the granules are generally softer than drum product.
Powder is compressed between two counter-rotating rollers at high pressure, then crushed and screened into uniform granules — no water, no binder, no dryer. This is the only one of the three that works at feed moisture below 10%, which makes it the default choice for NPK compounds, heat-sensitive biological fertilizers and industrial salts. The trade-off is granule shape (irregular, not spherical) and stricter upstream premixing.
| Parameter | Rotary Drum | Disc Pan | Roller Press |
|---|---|---|---|
| Feed moisture | 25–35% | 20–30% | Below 10% (dry) |
| Water or binder | Required | Required | None |
| Granule shape | Round, uniform | Round, slightly irregular | Irregular, flake-formed |
| Typical size | 2–5 mm | 2–6 mm | 2–5 mm after screening |
| Green strength | Medium, needs curing | Low to medium | High |
| Drying needed | Yes, full dryer + cooler | Yes, lighter dryer | No dryer |
| Typical output | 5–30 t/h | 1–5 t/h per pan | 1–20 t/h |
| Capex for same output | High | Low | Medium |
| Energy profile | High (drying fuel) | High (drying fuel) | Low (motors only) |
| Best materials | Organic, compound, high-moisture mixes | Organic fines, small lines | NPK, bio-organic, heat-sensitive, salts |
| Footprint | Large | Small | Smallest |
| Maintenance focus | Drum tyres, girth gear, dryer seals | Pan drive, spray nozzles | Roller shell wear, hydraulic pressure |
Most mature plants end up with two of the three. A common organic configuration is drum granulation for the main stream with a disc pan shaping the recycled fines; a common NPK configuration is roller press compaction followed by a light coating drum. The combinations exist because the cheapest answer is rarely the best single machine — it is the right machine at the right stage.
We build all three routes and will tell you when one of them is wrong for your project. Send your material specification and target output, and review our fertilizer granulator machine range and reference installations before you choose.